News

1. Installation conditions of metal detector

Install this device in a location that meets the following conditions.

Ø Places where the temperature is not lower than 0°C and not higher than 40°C.

Ø Places with humidity in the range of 30~85% and no condensation.

Ø There is no direct sunlight, and there are no heating appliances such as stoves and heaters nearby.

Ø The fluctuation range of power supply voltage does not exceed ±5%.

Ø Away from vibration sources, places that are not prone to vibration.

Ø A place with less dust.

Ø Places without volatile flammables, corrosive gases and salt water.

Ø Places where the hot and cold air of the air conditioner does not blow directly against the equipment.

2. Precautions for installation of metal detector

The power supply should be a self-contained system and should be separated from the power supply system of noise-generating equipment and other devices (large motors, packaging machines, etc.). And it should be connected to an outlet closer to the power source.

Please do not wire in multiple directions. If a heavy object is placed on the power cord, it will crush the cord and cause a fire or electric shock.

The power cord should be kept away from heating appliances. Before unplugging the power plug, you should turn off the power switch and pull out by holding the plug.

When this equipment is connected (connected) to other equipment (front and rear conveyors, etc.), malfunction may occur. In this case, please do not connect with other equipment and ground it separately.

3. Adjustment of the plane height of the conveyor belt between the metal detector and the front and rear devices

Adjust the plane height between the equipment and the front and rear conveyor belts to the same level. There should be no gaps between the device's foot bolts and the ground to avoid shaking. After adjustment, the brake nut must be tightened with a wrench.

4. Connection of power supply and grounding of metal detector

To avoid danger, install a circuit breaker in the middle of the power supply to this equipment. Also, if it is used in a humid environment, an earth leakage circuit breaker should be installed.

To avoid electric shock and ensure stable operation of this equipment, the power plug must be grounded. (Use a soft copper wire with a diameter of 1.6mm or a metal wire with equivalent strength that is not easy to corrode. The grounding impedance must be less than 100 ohms.)